When installing a Slate roof, there are several steps that you should take to ensure the best possible outcome. In this article, you will get some helpful tips to install a slate roof successfully. The roofing material has to be specifically cut to fit your home so you may need to hire a contractor experienced with applying this material as well. The next step is sealing any cracks or holes in the roof before beginning the installation of the new panels.
Once the crack or hole has been sealed, it will not be visible once the new panel is installed over it so keep your eye out for it. The next step is to clean the roof of any loose material before sealing it. This can be done by taking a hose and spraying it down the roof or by using a pressure washer after wetting it down with water. If you have any gutters installed in your home, then you will need to clean them out as well.
There are several steps that you should take to ensure that the new slate does not come off at this point. These include using a special sealant as well as a special waterproofing primer before applying the slate to your roofing surface. Once the slate has been applied, you will want to apply two coats of sealant over all surfaces where the slates meet other surfaces covered by other materials.
You will also want to start applying a clear coating to the slates themselves. This clear coat helps protect the slate from cracking and helps make sure that it does not have any loose spots where moisture can get through. At the same time, you should be using water-based latex paint over the entire surface of your roof. This is called an undercoat and it allows the slate to stick securely to your roofing substrate.